Electronic Fuel Injection
From John Clarke Mills Project Wiki
m (→Research) |
(→Research) |
||
Line 27: | Line 27: | ||
MegaSquirt and Crane XR700: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,275308/<br/> | MegaSquirt and Crane XR700: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,275308/<br/> | ||
MegaSquirt and Tach signal: http://msefi.com/viewtopic.php?p=131300&highlight=distributor<br/> | MegaSquirt and Tach signal: http://msefi.com/viewtopic.php?p=131300&highlight=distributor<br/> | ||
+ | 36-1 tooth, Ford EDIS ignition (future): http://www.megamanual.com/ms2/EDIS.htm<br/> | ||
==Master parts list== | ==Master parts list== |
Revision as of 05:27, 14 November 2006
Contents |
Building
Calibrating temperature sensors
TWM 40mm throttle bodies, TPS, fuel rail, and regulator
Fuel plumbing
Final EFI assembly
Research
Initial thoughts: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/p,319629
FIdle and MAP: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/p,319717
Fuel plumbing, etc: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,204528/
Thermistor sensors: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/p,324206/highlight,/#324206
Throttle linkage: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,280025/
AN Fittings: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,280238/
MegaSqiurt info
Pickups (Hall, coil, VR): http://www.megamanual.com/ms2/pickups.htm
MegaSquirt and Crane XR700: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/t,275308/
MegaSquirt and Tach signal: http://msefi.com/viewtopic.php?p=131300&highlight=distributor
36-1 tooth, Ford EDIS ignition (future): http://www.megamanual.com/ms2/EDIS.htm
Master parts list
- 2 TWM 2900 DOCE 40mm's (2900 + 2910)
- TWM Fuel rail
- TWM pressure regulator (2800-6401)
- TWM TPS switch and plug
- Mangoletsi intake manifold
- 318 water manifold
- Copper pipe bypassing manifold (to heater box)
- Electronic under-car fuel pump (40+ PSI. for a Ford F150)
- MegaSquirt (MS II v3. keeping distributor for now, future expansion in mind)
- O2 sensor (Innovate LC-1)
- 12' MegaSquirt pre-labeled wiring harness
- Mechanical fuel pump blockoff plate
- Two Bosch temperature sensors (62110788115)
- Painless wiring 7 circuit fuse box (dual relay hot switched relays)
- OEM BMW intake manifold gaskets
- Injectors (22# Bosch Pink Tops)
- Lokar throttle cable 36"
- Fuel plumbing, filters, AN fittings, etc
- Mangoletsi barb for brake vacuum
- Grommets
- More band clamps (big ones for fuel pump)
- Hose mounting clamps
- 50mm TWM air horns
- 470 ohm resistor (in between MS and O2 sensor)?
Notes to self
(none at this time)