Electronic Fuel Injection
From John Clarke Mills Project Wiki
(Difference between revisions)
Line 9: | Line 9: | ||
---- | ---- | ||
* 2 TWM 2900 DOCE 40mm's | * 2 TWM 2900 DOCE 40mm's | ||
- | * Weber intake manifold | + | * TWM Fuel rail |
- | * 318 water manifold (12mm Bosch water temp sensor) | + | * TWM pressure regulator |
- | * Generic IAT (Intake air temp) sensor from | + | * TWM TPS switch and plug |
+ | * Injectors (VW Corrado 24# high imp injectors. VWvortex) | ||
+ | * Weber intake manifold (http://www.piercemanifolds.com/Images/Catalog/99002.093.htm) | ||
+ | * 318 water manifold (12mm Bosch water temp sensor. Could I get a GM one that fits here?) | ||
+ | * Generic IAT (Intake air temp) sensor from DIYAutoTune | ||
* Copper pipe bypassing manifold (to heater box) | * Copper pipe bypassing manifold (to heater box) | ||
* Electronic under-car fuel pump (Leaving fuel tank untouched. Under car mounted) | * Electronic under-car fuel pump (Leaving fuel tank untouched. Under car mounted) | ||
* MegaSquirt (MS II v3. keeping distributor for now, future expansion in mind) | * MegaSquirt (MS II v3. keeping distributor for now, future expansion in mind) | ||
- | + | * O2 sensor (Innovate LC-1? Can I get something cheaper that plugs right into MS?) | |
- | * O2 sensor ( | + | * 12' MegaSquirt pre-labeled wiring harness |
- | * | + | * 470 ohm resistor (in between MS and O2 sensor (True or what? Read it at DIYAutoTune)) |
- | * 470 ohm resistor (in between MS and O2 sensor) | + | |
---- | ---- |
Revision as of 03:43, 1 June 2006
For now, just little notes. Nothing organized:
Important posts:
Initial thoughts: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/p,319629
FIdle and MAP: http://www.bmw2002faq.com/component/option,com_forum/Itemid,57/page,viewtopic/p,319717
- 2 TWM 2900 DOCE 40mm's
- TWM Fuel rail
- TWM pressure regulator
- TWM TPS switch and plug
- Injectors (VW Corrado 24# high imp injectors. VWvortex)
- Weber intake manifold (http://www.piercemanifolds.com/Images/Catalog/99002.093.htm)
- 318 water manifold (12mm Bosch water temp sensor. Could I get a GM one that fits here?)
- Generic IAT (Intake air temp) sensor from DIYAutoTune
- Copper pipe bypassing manifold (to heater box)
- Electronic under-car fuel pump (Leaving fuel tank untouched. Under car mounted)
- MegaSquirt (MS II v3. keeping distributor for now, future expansion in mind)
- O2 sensor (Innovate LC-1? Can I get something cheaper that plugs right into MS?)
- 12' MegaSquirt pre-labeled wiring harness
- 470 ohm resistor (in between MS and O2 sensor (True or what? Read it at DIYAutoTune))
Pricing from TWM:
- 2 40mm TB's - 360x2
- Fuel rail - 180
- TPS - 80
- TPS Plug - 16
- Fuel reg. - 260
- TOTAL - $1256